There are different hand tools for Inserts series.
KNT01, KNT02 and KNT03 are hand tools for Inserts series in hardened steel; with threaded pin and anvil with black oxide finish.
In the next table you can find the hand tool with its corresponding Insert series:
Hand Tool INSERT |
Matching INSERTS Series |
Material and finish |
KNT01 |
KNM(L), KNHM(L) |
Hardened steel; threaded pin and anvil with black |
KNT02 |
KNJ and KNHJ |
|
KNT03 |
KNHM(L)16+ |
Here you'll find the hand tool for Insert tool part numbers with the matching Inserts.
KNT01
|
PART NO - KNT01 |
MATCHING INSERTS |
Also other sizes on request.
KNT02
|
PART NO - KNT02
|
MATCHING INSERTS |
Other sizes on request
KNT03
The head diameter for KNT03 can be D= 40 or 50mm.
|
PART NO - KNT03 |
MATCHING INSERTS |
D head diameter |
40 |
|||
50 |
|||
Other sizes on request.
The installation steps for the hand tools KNT are as follows:
Step 1:
First, screw the INSERTs onto the threaded pin up to the end of the thread.
Step 2:
Next, you screw the INSERTS into the workpiece until the keys stop on the chamfer or the favored depth is reached.
Step 3:
Then, drive in the keys with short and precise hammer taps on the anvil. Keys can be controlled after each tap until the favored depth is reached or until the anvil stops on the chamfer.